|
Jiangyin Ruixiang Machinery Manufacturing Co., Ltd.
|
News
1. Use wire drawing machines to pull out the wire of the inner circle.
2. Use cutting machine to cut off the tires which are removed inner circle steel wire.
3. Put the tires into the tire breaker to crush, until the rubber block is 5cm*5cm.
4. Coarse crusher, input the rubber block to coarse crusher for crushing, according to the hole's size of the slotted screen in the bottom of the machine, finally the rubber granule will come to 3-5 mesh.
5. This process is only apply to the fiber tires, because there is about 5% fiber in the tires, after crushing, the fiber and granule should be separated.
5-30 mesh rubber powder process flow:
1. Use wire drawing machines to pull out the wire of the inner circle.
2. Use cutting machine to cut off the tires which are removed inner circle steel wire.
3. Put the tires into the tire breaker to crush, until the rubber block is 5cm*5cm.
4. Put the 5cm*5cm rubber block into the rubber crusher for milling again and again, until the powder is 5-25 mesh. According to the slotted screen blanking, and then sort powder and the fiber and wires.
5. In the pure wire tires, there are 25% wires in them. And there is 5% fiber and 20% wires in the radial tires.
4-80 mesh rubber powder process flow:
1. Use wire drawing machines to pull out the wire of the inner circle.
2. Use cutting machine to cut off the tires which are removed inner circle steel wire.
3. Put the tires into the tire breaker to crush, until the rubber block is 5cm*5cm.
4. Put the 5cm*5cm rubber block into the rubber crusher for milling again and again, until the powder is 5-25 mesh. According to the slotted screen blanking, and then sort powder and the fiber and wires.
5. Put the 5-25 mesh rubber powder into the fine rubber machine. And until the rubber powder up to 40-80 mesh. The millstone's space in the machine can be adjusted.
